VSI LOW VOLTAGE SOLUTIONS LLC is an installation contractor out of Washington Court House, Ohio, built around a simple idea: a building's systems share one skeleton — the riser. Power, flow and the equipment that lands it all belong to the same crew.
VSI LOW VOLTAGE SOLUTIONS LLC is a limited liability company organized in Ohio, operating from 711 Washington Ave, Washington Court House, 43160. The crew carries three trade disciplines under one roof:
Riser-E — power & signal. Electrical contracting and wiring, panels and outlets, lighting systems from parking lots to tunnel and runway work, low-voltage communications, structured cabling, fiber, alarms and security, building automation and controls, PV solar and standby generators.
Riser-M — air & flow. HVAC installation and ductwork, boilers and furnaces, chilled-water and hydronics, commercial and industrial refrigeration, plumbing and fixtures, natural gas and process piping, sprinklers and waterless suppression, and balancing work that proves it all out.
Riser-X — set in place. Commercial and industrial doors, elevators, escalators and moving walks, conveyors and material handling, machine rigging and millwright work, mechanical insulation, power-generation equipment, vehicle lifts, vaults and specialty apparatus.
Every circuit lands per manufacturer spec, engineered drawings and applicable code. If a field condition conflicts, it goes back to the engineer — never the hacksaw.
Rough work gets inspected before the ceiling closes. Testing, balancing and commissioning records are part of the install, not an extra.
When electrical, mechanical and specialty work share the same shaft, the same shop coordinates it. Fewer fingers in the riser, fewer surprises at turnover.
Trade discipline doesn't change with the trade. A fiber backbone and a chilled-water main follow the same four steps: write the scope, rough the path, connect the device, verify the result.
That sequence is what lets one shop cover 173 service circuits without dropping trades — the method stays the same even when the material changes.
The scope is installation-centered — systems installed, equipment set, lines and cabling landed. Some circuits (waterless suppression, fire extinguishers, electronic controls) include repair and service as listed on the riser schedule. Ongoing building maintenance contracts are not the scope.
No. Alarm, fire, security and surveillance work is installation only — the equipment and wiring go in per code; monitoring is a separate contract between the owner and a monitoring company.
Both. The schedule includes household items — generators, home automation, pet fencing, water heaters — alongside industrial rigging, process piping, refrigeration and runway lighting.
File a service ticket with the location and which riser the work belongs to. The shop scopes the circuit — site visit when needed — and returns a written scope of work. Complex sets (elevators, boilers, rigging) always include a site survey.
Send the shop a location and a scope — we'll figure out which riser it belongs to.
Contact the Shop